You are here

FAQ

If you are accustomed to using the command line interface on routers and switches, then you are probably in the habit of saving the switch configuration before rebooting...

Alpha Ring is a redundant protocol created by EtherWAN...

In a ring topology, each switch constantly monitors port status to detect ring failure...

To upgrade the firmware, a TFTP server is required. The firmware file for the switch is in a .TGZ or .IMG format. This is a compressed file; however, it should not be decompressed before updating the switch...

  • Connect PC and EtherWAN switch via DB9 console cable
  • Open terminal emulation program (Putty, HyperTerminal, etc.)
  • Baud rate: 115200, Data bits: 8, Stop bits: 1, Parity: none
  • Type following commands...
  • Connect PC and EtherWAN switch via DB9 console cable
  • Open terminal emulation program (Putty, HyperTerminal, etc.)
  • Baud rate: 115200, Data bits: 8, Stop bits: 1, Parity: none
  • Type following commands...

The combo port priority can only be configured via CLI from the serial port of the switch or through Telnet...

There are 2 ways to calculate latency; Cut through and Store and Forward...

Press and hold the reset button for 15 seconds, and the password will be restored to the default value...

EtherWAN Managed Switches are compliant with the IEEE802.3x standard...

Pages