You are here

FAQ

If the password to the switch is forgotten or lost, it can be reset through the reset button...

Connect to the Web Interface by entering the switch’s (management VLAN) IP address into your Web Browser...

This document describes accessing the EtherWAN Switch by using Telnet, SSH, or serial ports to configure the switch, navigating the Command Line Interface (CLI), typing keyboard shortcuts, and moving between the levels...

If you are accustomed to using the command line interface on routers and switches, then you are probably in the habit of saving the switch configuration before rebooting...

Alpha Ring is a redundant protocol created by EtherWAN...

In a ring topology, each switch constantly monitors port status to detect ring failure...

To upgrade the firmware, a TFTP server is required. The firmware file for the switch is in a .TGZ or .IMG format. This is a compressed file; however, it should not be decompressed before updating the switch...

  •  Connect PC and EtherWAN switch via DB9 console cable
  •  Open terminal emulation program (Putty, HyperTerminal, etc.)
  •  Baud rate: 115200, Data bits: 8, Stop bits: 1, Parity: none
  • Type following commands...
  • Connect PC and EtherWAN switch via DB9 console cable
  • Open terminal emulation program (Putty, HyperTerminal, etc.)
  • Baud rate: 115200, Data bits: 8, Stop bits: 1, Parity: none
  • Type following commands...

Pages

Feedback ✉